• SELF-ALIGNING BALL BEARING
  • SPHERICAL ROLLER BEARING
  • INSERT BALL BEARINGS
  • ADAPTER SLEEVE
  • WITHDRAWAL SLEEVE
  • VIBRATION SCREEN BEARING
  •     
  • Self-Aligning Ball Bearing Pioneer
  • Since 1966
  • HOME > PRODUCT > ADAPTER SLEEVE
    The product selection
    KML

    ADAPTER SLEEVE

    H23 SERIES

    H2 SERIES

    H3 SERIES

    H31 SERIES

    H30 SERIES


    Adapter sleeves

    Adapter sleeves are supplied complete with lock nut and locking washer. The sleeves are slotted and the outer part taper is 1:12. The dimensions of the adapter sleeves comply with ISO 113/I. standard. Adapter sleeves of bigger diameter are produced as standard with oil ducts at the threaded side and an oil distributor groove on the outside surface – designation OH…H. The sleeves with distributor grooves in the bore as well as the outside surface are designated OH…HB. The sleeves with an oil supply duct at the side opposite to the threaded section and a distributor groove in the outside surface are designated OH. The sleeves with a distributor grooves on the surface as well as the bore are designated OH…B.

    Lock nuts and withdrawal nuts

    Lock nuts and withdrawal nuts

    Lock nuts are used for fixing the bearing inner rings on the adapter sleeves or directly on the shaft, eventually for mounting and dismounting the bearing on the withdrawal sleeves. Lock nuts are equipped with grooves on the outer diameter to facilitate the manipulation with them. Dimensions of lock nuts are in accordance with ISO 2982.


    Locking washers, locking clip

    Locking washers, locking clip

    Locking washers are used for fixing the lock nuts of smaller diameter and the locking clips are used for fixing the lock nuts of bigger diameter. Locking washers are made of a deep-drawing sheet steel and their dimensions comply with ISO 2982 standard. Locking clips are also made of a deepdrawing sheet steel and they are attached to withdrawal sleeve with a bolt. The bolt and the washer are included in the delivery.